Zitat:
|
Zitat von power-gamer
hmm. so the aftermarket cam with 280 degrees wont run on the standard g201? it would only run with the deto ecu?
and would an applause-engine run better with a GTI-cam? and would it have a bigger output (more power on the wheels) ?
|
No the 280 degree cam wont run on the deto ecu.
The euro G201 has the same cam as the deto/jap spec G201 so yes the applause will have more power with it.
Better spend some more cash and get the High torque cam from rospen motorsport.
With that cam the engine still idles normal (no hunting) and gives a bit more power then the std G201 cam.
That came has more valve lift then the std G201 and other timings.
Besides with most of the "wilder" cams the power will come at higher rpms . so even if they ran fine with the std ecu , you wont make much more power because you cant get above 6500 rpm.
On the daihard forum in aus , there was 1 person who had the 250 degree cam from rospen.
It did ran on his original ecu but it didnt ran really well.
And if you get an aftermarket ecu and an "250/280" degree cam , you will also need other valve springs. (rospen also provides them)